AP-600 Ultra Belt Bonder
Full feature automatic heat press V12.2010
Operational guide
Instructions and Training Information/AP-600 Ultra Operational Guide/AP-600 Ultra.300.jpg)
Always use correct power source for your AP-600. Whenever possible, plug unit directly into receptacle, avoiding extension cords which can cause power drops.
Keep fan clear of obstructions to allow free air flow.
Blockage of air flow will result in uneven cooling and
imperfect splices.
Instructions and Training Information/AP-600 Ultra Operational Guide/Hold Splice Rail.300.jpg)
Instructions and Training Information/AP-600 Ultra Operational Guide/Split Rail.300.jpg)
The AP-600 heat press is designed to be used with a splice rail made
specifically for the belt type you are using. These rails allow for your belt type to be held in the correct position for proper cook cycles.
Instructions and Training Information/AP-600 Ultra Operational Guide/AP-600 Ultra(right).300.jpg)
Always load the splice rail into the center area of the heated plattens. This will distribute the spring pressure evenly when the AP-600 is closed. Increased compression can be applied
Instructions and Training Information/AP-600 Ultra Operational Guide/AP-600 Ultra(left).300.jpg)
to spring closure, by adjusting the hinge leg attachment screws. Plattens are uniformly heated top and bottom for proper melt flow of most belting types.
Your AP-600 is equipped with a “set and forget” control box. The external control modules allow you to select specific heat temperatures
Instructions and Training Information/AP-600 Operational Guide/Set and Forget.300.jpg)
for the heated top and bottom platens. You may also adjust the
Instructions and Training Information/AP-600 Ultra Operational Guide/Temp and Timer.300.jpg)
soak time or heat time. Once these values are determined and set, the control box will operate to these settings without further attention. The AP-600 control box is pre-set at the factory to a 30 minute cool down cycle. The timer controls are located inside of the box.
Do not interrupt the cooking cycle, once the control box has been turned on. If
you need to stop the cycle, turn the control
box to the power off which will reset the digital controller. This will then start the entire cycle again
Instructions and Training Information/AP-600 Ultra Operational Guide/Caution.300.jpg)
Do not use the AP-600 heat press where it can be exposed to water or wet conditions. This could cause damage to the control box and pose a health hazard to the operator.
Instructions and Training Information/AP-600 Ultra Operational Guide/Caution2.300.jpg)
This unit is equipped with an internal line fuse which will protect your unit against electrical overload and dead short situations .If the unit completely losses power when the power switch is energized, and you have exhausted all other possibilities, check this fuse for integrity.
Instructions and Training Information/AP-600 Ultra Operational Guide/Wires.300.jpg)
This condition normally indicates a major electrical problem with this unit. Care should be taken to locate and correct the cause of the malfunction before resuming the use of this device.
Instructions and Training Information/AP-600 Ultra Operational Guide/Danger.300.jpg)
When working on this control box, always remove
power cord from power source.